Steering and Braking R2.8 CM2220 R101B Page 1-32 Section 1 - Installation by Subsystem Figure 2 - Power Steering Pump Connections 1 Low-pressure - 16 mm [0.63 in] OD beaded hose, 22 mm [0.86 in] clamping distance 2 High-pressure - M16 - 1.5 6H banjo fitting. Connect all power steering lines to the pump. The outlet of the power steering pump uses a banjo connection, shown in Figure 3. Install new washers on both sides of the banjo connection and then tighten to specification. While applying the final torque, make sure to counter the torque with the fitting on the power steering pump to reduce the possibility of damage to the power steering pump threads. Torque Value:
40 N•m [ 30 ft-lb ] To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com