R2.8 CM2220 R101B Electrical System Section 1 - Installation by Subsystem Page 1-43 It is important for all harness leads to be properly routed and supported to eliminate wire chaffing and strain on the mating connectors. The ECM connector/harness must be supported no greater than 100 mm [4 in] away from the connection point. Engine Control Module The ECM must be mounted in the engine compartment away from high temperatures, road spray, and dirt. The ECM must not be engine-mounted. Figure 8 shows the dimensions and acceptable attachment locations for the ECM. To reduce vibration to the module, isolators (1) should be used at the mounting locations.
Figure 8 - ECM Dimensions and Mounting Locations 1 Representative optional ECM isolator The acceptable ECM mounting orientation is shown in Figures 9 and 10. The preferred ECM mounting orientation has been shown to minimize the accumulation of moisture and dirt on the ECM connectors, and maximize the transfer of heat away from the ECM. To buy Cummins Parts and Service Manuals, Training Guides, or Tools go to our website at https://store.cummins.com