RECONDITIONING THE ENGINE (S/N 522311001 & ABOVE) (CONT’D) Figure 60-80-179 Cylinder, Checking Clean the engine block and inspect for damage. Figure 60-80-177 Check the cylinders with engine block longitudinal (a) and transverse (b) axis and in three planes [Figure 60- 80-179] . P-63034 Specifications: Cylinder Bore. . . . . . . . . . . . . . . . . 3.7008 - 3.7016 inch. (94 - 94.02 mm) Wear Limit . . . . . . . . . . . . . . . . . . . . 3.59 inch. (94.1 mm) Install the main bearing caps [Figure 60-80-177] . Tighten the main bearing cap bolts as follows: Initial Torque . . . . . . . . . . . . . . . . . . . . 22 ft.-lb. (30 N•m) 1st Stage Angle . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . 60° 2nd Stage Angle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60° Figure 60-80-178 P-63035 Using a dial indicator gauge check the cylinders [Figure 60-80-178] . 442 Excavator 60-80-47 Service Manual b 1 2 a 1 2 3 b 1 2 3 b a 1 2 b 1 2 3 B-14697