RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-47 Assembly (Cont'd) Figure 60-81-45 P-56927 Put sealing compound on the rear cover [Figure 60-81- 47] . P-56926 Figure 60-81-48 Install the main bearing caps/main bearing assembly [Figure 60-81-45] . Install the caps in the original locations. Figure 60-81-46 P-56928 Install the rear cover complete with a new rear seal [Figure 60-81-48] . NOTE: Make sure the rear cover oil pan surface aligns with the engine block surface. CD-15554 Tighten the main bearing cap bolts as follows [Figure 60- 81-46] : Tighten the bolts to 15 ft.-lb. (21 N•m) torque in the order shown. Initial Torque . . . . . . . .
. . . . . . . . . . . . 37 ft.-lb. (50 N•m) 1st Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60° 2nd Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45° 442 Excavator 60-81-14 Service Manual