RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-59 Assembly (Cont'd) Figure 60-81-57 CD-15567 Tighten the front cover bolts to 15 ft.-lb. (21 N•m) torque [Figure 60-81-59] . P-56933 Figure 60-81-60 Put sealing compound on the front cover sealing surface [Figure 60-81-57] . NOTE: Make sure the camshaft/centrifugal governor connecting is clean and free of oil. Figure 60-81-58 P-56935 Make sure the mating surfaces are clean and free of oil and install the crankshaft gear on the crankshaft [Figure 60-81-60] . P-56934 Install the front cover with the new shaft seals on the engine block [Figure 60-81-58] . NOTE:
Make sure the oil pan sealing surface on the front cover aligns with the sealing surface on the block [Figure 60-81-61 on Page 18]. 442 Excavator 60-81-17 Service Manual