Bobcat Company 442 — Assembly

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-55 Assembly (Cont'd) Install a piston ring compressor on the piston rings. Figure 60-81-53 P-56932 Tighten the connecting rod bolts as follows [Figure 60- 81-55] : P-56931 Initial Torque . . . . . . . . . . . . . . . . . . . . 22 ft.-lb. (30 N•m) 1st Step Angle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° 2nd Step Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .60° Install the piston/connecting rod assembly in the engine block [Figure 60-81-53] . NOTE: If the connecting rod bolts are still serviceable, do not reuse the bolts more than five times. NOTE:

The flywheel symbol on the piston must be toward the flywheel. Figure 60-81-56 Figure 60-81-54 CD-15564 CD-15562 Check that the connecting rods can be easily moved back and forth on the crank pin [Figure 60-81-56] . Install the connecting rod cap on the connecting rod. The numbers must be aligned [Figure 60-81-54] . 442 Excavator 60-81-16 Service Manual