Bobcat Company 442 — Assembly

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-67 Assembly (Cont'd) Figure 60-81-65 P-56943 Install the camshaft timing tool [Figure 60-81-67] . P-56940 Figure 60-81-68 Install the crankshaft dolly on the holding plate [Figure 60-81-65] . Figure 60-81-66 P-56944 Install the camshaft gear and bolt [Figure 60-81-68] . NOTE: All mounting surfaces must be clean and free of oil. P-56942 Using a torque multiplier, tighten the bolt an additional 210 ° [Figure 60-81-66] . NOTE: Screw the crankshaft timing tool back in as far as it will go. Turn the crankshaft clockwise against the stop. The piston at the front cover is at the TDC position.

442 Excavator 60-81-19 Service Manual