RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-103 Cylinder, Checking Clean the engine block and inspect for damage. Figure 60-81-101 Check the cylinders with engine block longitudinal (a) and transverse (b) axis and in three planes [Figure 60- 81-103] . P-56722 Specifications: Cylinder Bore. . . . . . . . . . . . . . . . . .3.7008 - 3.7016 inch. (94 - 94.02 mm) Wear Limit . . . . . . . . . . . . . . . . . . . . 3.59 inch. (94.1 mm) Install the main bearing caps [Figure 60-81-101] . Tighten the main bearing cap bolts as follows: Initial Torque . . . . . . . . . . . . . . . . . . . . 37 ft.-lb. (50 N•m) 1st Stage Angle . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . 60° 2nd Stage Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45° Figure 60-81-102 P-56723 Using a dial indicator gauge check the cylinders [Figure 60-81-102] . 442 Excavator 60-81-28 Service Manual b 1 2 a 1 2 3 b 1 2 3 b a 1 2 b 1 2 3 B-14697