Bobcat Company 442 — Rear Cover Seal Removal And Installation

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-136 Rear Cover Seal Removal And Installation 0.803±0.008 inch (20.4±0.2 mm) Figure 60-81-134 B-14700 When installing the new shaft seal, use the dimension shown in [Figure 60-81-136] . P-56755 Figure 60-81-137 Remove the rear cover shaft seal [Figure 60-81-134] . Figure 60-81-135 P-56757 Use the seal driver tool and install to the correct depth [Figure 60-81-137] . See “Deutz Engine Tools Identification Chart” on page 1. CD-15439 Clean the seal seating surface [Figure 60-81-135] . Inspect the cover for damage, replace as needed. 442 Excavator 60-81-38 Service Manual