Bobcat Company 442 — Piston Pin, Checking

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Piston Pin, Checking Figure 60-81-154 Piston, Checking (Cont’d) Figure 60-81-153 B-8230 P-56784 Check piston pin for wear [Figure 60-81-154] . Specifications: Pin O.D. . . . . . . .1.180-1.181 inch. (29.995-30.0 mm) Using new rings, measure the ring grooves using a feeler gauge [Figure 60-81-153] . Specifications: Wear Limit 1st Ring. . . . . . . . . . . . . . . . . . . . . . . . Trapezoidal Slot 2nd Ring . . . . . . . . . . . . . . . . . . . . 0.0078 in (0.20 mm) 3rd Ring . . . . . . . . . . . . . . . . . . . .

0.0059 in (0.15 mm) Measure the trapezoidal slot with the trapezoidal slot gauge [Figure 60-81-153] . If a distance is present between the gauge and piston, the piston is serviceable [Figure 60-81-153] . If the gauge rests against the piston, replace the piston [Figure 60-81-153] . 442 Excavator 60-81-45 Service Manual