Bobcat Company 442 — Piston, Checking

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-152 Piston, Checking Figure 60-81-150 P-56783 Measure the ring gap with a feeler gauge in the cylinder [Figure 60-81-152] . P-56781 Specifications: Wear Limit 1st Ring Gap . . . . . . . . . . . . . . . . . . 0.031 in. (0.8 mm) 2nd Ring Gap . . . . . . . . . . . . . . . . . 0.098 in (2.5 mm) 3rd Ring Gap . . . . . . . . . . . . . . . . . . 0.043 in (1,1 mm) Remove the piston rings from the piston [Figure 60-81- 150] . Remove the piston from the connecting rod. See Connecting Rod, Checking to check connecting rod specifications.

(See Connecting Rod, Checking on Page 60-81-41.) Figure 60-81-151 P-56782 Clean and inspect piston and piston ring grooves [Figure 60-81-151] . 442 Excavator 60-81-44 Service Manual