RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Connecting Rod, Checking (Cont'd) Figure 60-81-149 CD-15454 Measure the big end bore [Figure 60-81-149] . If the measurement is the same as the specific valve, the necessary preload on the bearing halves will be obtained. Specifications: Big End I.D. . . . . . . . . . . . . . . . . . . . 2.303 + 0.0008 inch (58,5 + 0,02 mm) Remove connecting rod cap. Install new bearing halves. Tighten the connecting rod cap nuts and tighten as listed above. Measure the bearing halves: Big End Bearing I.D. . . . . . . . . . . . 2.1662 - 2.1675 inch. (55.024 - 55.055 mm) Each Undersize . . . . . . . . . . . . . . . . . . . .
. . . 0.010 inch. (0,25 mm) Limit For Undersize . . . . . . . . . . . . 2.1466 - 2.1478 inch. (54.524 - 54.555 mm) Radial Clearance Wear Limit . . . . . . . . . . . . . . . . .0.005 inch. (0,12 mm) Check the connecting rod, without bearing halves, on a connecting rod tester. Specifications: Parallel Check-Tolerance. . . . . . . .0.118 inch. (0.03 mm) Over a Distance of . . . . . . . . . . . . . . 3.94 inch. (100 mm) Squareness Check-Tolerance . . . .0.002 inch. (0,05 mm) 442 Excavator 60-81-43 Service Manual