Bobcat Company 442 — Front Cover Assembly

RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) If the torque control was disassembled, do the following procedure to assemble: Front Cover Assembly Figure 60-81-201 Figure 60-81-199 3 2 1 6 4 5 P-56839 P-56832 Turn (Item 1) into (Item 2) until lightly bottomed, back (Item 1) [Figure 60-81-201] out 1-1/2 turns. Inspect the front cover for damage [Figure 60-81-199] . Replace the front cover as needed. Tighten the lock nut (Item 3) [Figure 60-81-201] to 12 ft.- lb. (16 N•m) torque. Figure 60-81-200 Turn (Item 4) as far as it will go into (Item 5) [Figure 60- 81-201] . Turn back one full turn. Tighten the lock nut (Item 6) [Figure 60-81-201] to 53 in.- lb.

(6 N•m) torque. Figure 60-81-202 P-56838 Inspect the individual parts of the torque control assembly [Figure 60-81-200] . Replace the parts as needed. P-56840 Install the torque control into the front cover [Figure 60- 81-202] . 442 Excavator 60-81-60 Service Manual