RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-205 Front Cover Assembly (Cont'd) Figure 60-81-203 P-56843 Tighten the clamp nut to 88 in.-lb. (10 N•m) torque [Figure 60-81-205] . P-56841 Figure 60-81-206 Install the torque control assembly to the dimensions taken [Figure 60-81-203] or use the procedure below: See “Front Cover Disassembly” on page 54. Measure the thread reach [Figure 60-81-203] . Specifications: Thread Reach . . . . . . . . . . . . . . . . . .0.252 ± 0.019 inch. (6,4 ± 0,5 mm) NOTE: Dynamometer testing may be necessary depending on engine performance.
Figure 60-81-204 P-56844 Press the camshaft seal into the front cover [Figure 60- 81-206] . See “Deutz Engine Tools Identification Chart” on page 1. NOTE: Do not put oil on the camshaft seal before installation. CD-15374 Install the clamp and nut [Figure 60-81-204] . 442 Excavator 60-81-61 Service Manual