RECONDITIONING THE ENGINE (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 60-81-229 Front Cover Assembly (Cont'd) Figure 60-81-227 P-56860 Assemble the roller lever with the idling lever and shaft [Figure 60-81-229] . CD-15398 Install the complete governor lever shaft assembly into the front cover. Measure the ball bearing by lightly pressing the roller lever [Figure 60-81-227] . Figure 60-81-230 Set the dial gauge to zero. Figure 60-81-228 1 P-56861A Tighten the bolts to 81 in.-lb. (9,2 N•m) torque [Figure 60-81-230] . CD-15399 Place dial indicator on ball bearing [Figure 60-81-228] . NOTE:
The longer space (Item 1) [Figure 60-81-230] on the governor lever shaft goes down toward the cover when installed. Make record of the two readings. The required tolerance is 0.0019 inch (0,05 mm). It is possible to install extra shims (max 0.0019 inch [0.05mm]) at (Items 1 & 2) [Figure 60-81-225 on Page 66] to get the required measurement. 442 Excavator 60-81-67 Service Manual