BOOM CYLINDER Figure 20-20-3 Testing Fully retract the bucket and arm cylinders. Lower the boom to the ground. With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. 1 Figure 20-20-1 P-33401 Remove the pin (Item 1) [Figure 20-20-3] . Figure 20-20-4 1 1 P-33396 Remove the bolt (Item 1) [Figure 20-20-1] from the rod end retaining pin. Figure 20-20-2 P-33403 Raise the cylinder and remove the shims (Item 1) [Figure 20-20-4] from both sides of the rod end. 1 P-33399 Remove the spacer (Item 1) [Figure 20-20-2] . 442 Excavator 20-20-1 Service Manual