BOOM CYLINDER (CONT’D) Figure 20-20-7 Testing (Cont’d) Figure 20-20-5 1 1 P-33395 Remove the hose (Item 1) [Figure 20-20-7] from the base end of the boom cylinder. P-36024 Install a block (Item 1) [Figure 20-20-5] under the cylinder housing. Figure 20-20-8 Figure 20-20-6 2 1 1 P-36026 Install a plug (Item 1) [Figure 20-20-8] on the hose. P-36025 Start the engine and retract the boom cylinder. Start the engine and retract the boom cylinder (Item 1) [Figure 20-20-6] . If there is any oil leakage from the base end fitting (Item 2) [Figure 20-20-8] on the boom cylinder, remove the cylinder for repair or replacement. Stop the engine.
With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. 442 Excavator 20-20-2 Service Manual