BOOM CYLINDER (CONT’D) Figure 20-20-10 Removal And Installation Fully retract the bucket and arm cylinders. Lower the boom to the ground. With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. 1 IMPORTANT P-33394 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. Disconnect the hose (Item 1) [Figure 20-20-10] from the rod end. I-2003-0888 Figure 20-20-11 Figure 20-20-9 1 2 2 1 P-33395 P-33391 Disconnect the hose (Item 1) [Figure 20-20-11] from the base end.
Remove the load sense line (Item 1) and two pilot hoses (Item 2) [Figure 20-20-9] . 442 Excavator 20-20-3 Service Manual