BASIC TROUBLESHOOTING (CONT’D) Figure 70-80-26 Checking The Electrical System (Cont’d) Figure 70-80-24 S/N 522311001 & Above 1 1 P-63620 With a multimeter, check the resistance to the compressor clutch (Item 1) [Figure 70-80-26] . P-40476 Figure 70-80-25 If there is no resistance value, replace the compressor clutch. ((See COMPRESSOR (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) on Page 70-141-1.).) S/N 528911001 & Above And S/N 528611001 & Above Figure 70-80-27 1 1 P-61567 If the fuses are good, disconnect the wire harness (Item 1) [Figure 70-80-24] or [Figure 70-80-25] from the compressor clutch wire.
P-63621 With a multimeter, check the voltage to the compressor clutch at the wire harness (Item 1) [Figure 70-80-27] . If the voltage reading is approximately 12 volts, the system is operating correctly. If there is no power at the clutch, reconnect the wiring harness to the compressor clutch. 442 Excavator 70-80-8 Service Manual