Bobcat Company 442 — Checking The Electrical System

BASIC TROUBLESHOOTING (CONT’D) Figure 70-80-42 Checking The Electrical System (Cont’d) 1 Figure 70-80-41 P-63628 A1 A2 A3 A4 Remove the switch panel (Item 1) [Figure 70-80-42] . P-63631 Figure 70-80-43 If there is voltage at the wiring harness, check the blower switch [Figure 70-80-41] for resistance. 1 With the switch in the OFF position, there should be zero resistance between all terminals. With the switch in the 1 position, there should be resistance between A4 terminal and the A3 terminal [Figure 70-80-41] . With the switch in the 2 position, there should be resistance between A4 terminal and the A2 terminal [Figure 70-80-41] .

P-63634 With the switch in the 3 position, there should be resistance between A4 terminal and the A1 terminal [Figure 70-80-41] . At the excavator cab, disconnect the wire harness (Item 1) [Figure 70-80-43] from the A/C switch. If any of the above resistance tests fail, replace the blower switch. Check the harness for voltage. The voltage should be approximately 12 volts. If the above resistance tests are good, check the A/C switch. If there is no voltage at the wiring harness, check the harness for broken wires. 442 Excavator 70-80-13 Service Manual