Bobcat Company 442 — Compressor Oil Check

GENERAL AIR CONDITIONING SERVICE GUIDELINES Compressor Oil Check The compressor oil should be checked as follows when oil is being added to an in service excavator. Compressor Oil Figure 70-90-49 There is a close affinity between oil and refrigerant. During normal operation, part of the oil circulates with the refrigerant in the system. Therefore, when checking the amount of oil in the system or replacing any system component, the compressor must be run in advance to insure return of oil to the compressor. 1 If the amount of refrigerant in the system has decreased, charge the system. (See SYSTEM CHARGING AND RECLAMATION on Page 70-130-1.) Open the cab door and windows.

Run the blower at maximum speed. P-63469 Run the compressor for at least 20 minutes at 800-1200 RPM. The compressor (Item 1) [Figure 70-90-49] is factory filled with 150-170 cc's of PAG oil (Poly Alkelene Glycol). Remove the compressor. (See COMPRESSOR (S/N 522311001 & ABOVE) on Page 70-140-1 or See COMPRESSOR (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) on Page 70-141-1.) Unlike engine oil, it is not necessary to frequently check or change the compressor oil. It is necessary to check, replenish or replace the compressor oil in the following cases: 1. When the evaporator, condenser or receiver-drier is replaced. 2. When refrigerant has leaked from the system. 3.

When refrigerant is suddenly released from the cooling cycle. 4. When any oil related problems occur in the cooling cycle. When one of the components (the evaporator, condenser or receiver-drier) is replaced, one ounce (30 cc) of PAG oil should be added for each component replaced. If the A/C compressor is changed, no oil should be added to the system, because the compressor comes factory filled with oil. NOTE: Only PAG oil should be used. Never mix R-12 and R-134a Oils. 442 Excavator 70-90-1 Service Manual