Bobcat Company 442 — Assembly

BOOM CYLINDER (CONT’D) Figure 20-20-59 Assembly (Cont’d) Figure 20-20-57 1 1 P-36066 Install the bearing (Item 1) [Figure 20-20-59] into the base end of the cylinder housing. P-36070 Apply thread lock adhesive (Loctite™ 270) to the threads and install the nut (Item 1) [Figure 20-20-57] . NOTE: The bearing can only be installed thru the snap ring side of the housing. Tighten the nut to 1512 ft.-lb. (2050 N•m) torque. Figure 20-20-60 Figure 20-20-58 1 1 P-36068 P-36083 Fully seat the bearing and install the snap ring (Item 1) [Figure 20-20-60] . Install a ring compressor on the piston (Item 1) [Figure 20-20-58] and compress the seal to the correct size.

Leave the piston in the compressor for about three minutes. Remove the rod and head assembly from the vise. 442 Excavator 20-20-17 Service Manual