Bobcat Company 442 — Assembly

BOOM CYLINDER (CONT’D) Figure 20-20-63 Assembly (Cont’d) 1 Figure 20-20-61 3 P-36064 1 2 Install the twelve bolts (Item 1) [Figure 20-20-63] . Tighten the bolts to 107 ft.-lb. (145 N•m) torque. P-36155 Clamp the base end of the cylinder in a vise and support the end of the housing with a block (Item 1) [Figure 20- 20-61] . Use care not to damage the cylinder housing. Figure 20-20-64 Support the rod assembly with wood blocks (Item 2) [Figure 20-20-61] . 2 1 Install a ring compressor (Item 3) [Figure 20-20-61] on the piston to compress the steel rings to the correct size. Push the piston into the housing.

Figure 20-20-62 3 3 4 4 P-36053 1 To allow the cylinder rod to be moved during installation do not install the boom load holding valve (Item 1) [Figure 20-20-64] until the cylinder has been installed on the excavator. For boom load holding valve installation on the excavator. (See Removal And Installation on Page 20- 200-1). Install the tubeline (Item 2) blocks (Item 3) and clamps (Item 4) [Figure 20-20-64] . P-36065 Install the head (Item 1) [Figure 20-20-62] in the housing. 442 Excavator 20-20-18 Service Manual