ARM CYLINDER Removal And Installation Testing Fully retract the bucket and arm cylinders. Fully retract the bucket and arm cylinders. Lower the boom to the ground. Lower the boom to the ground. With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. With the engine off and the key in the run position, move the joysticks to relieve hydraulic pressure. Figure 20-21-1 IMPORTANT When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system.
1 I-2003-0888 Figure 20-21-3 P-33406 1 Remove the hydraulic hose (Item 1) [Figure 20-21-1] from the base end of the arm cylinder. Figure 20-21-2 2 P-33406 2 Remove the hose (Item 1) [Figure 20-21-3] from the base end. 1 Remove the hose (Item 2) [Figure 20-21-3] from the rod end. P-36023 Install a plug (Item 1) [Figure 20-21-2] on the hose. Start the engine and retract the arm cylinder. If there is any oil leakage from the base end fitting (Item 2) [Figure 20-21-2] on the arm cylinder, remove the cylinder for repair or replacement. 442 Excavator 20-21-1 Service Manual