Bobcat Company 442 — Removal And Installation

BOOM OFFSET CYLINDER Figure 20-22-12 Removal And Installation Swing the boom to the right, fully extending the boom offset cylinder. 1 Lower the boom/bucket to the ground. Stop the engine. Figure 20-22-10 P-33701 Remove the pin (Item 1) [Figure 20-22-12] . 1 Figure 20-22-13 P-33699 Remove the bolt (Item 1) [Figure 20-22-10] . Installation: Tighten the bolt to 48-55 ft.-lb. (65-75 N•m) torque. Figure 20-22-11 1 P-33702 Place a board (Item 1) [Figure 20-22-13] between the cylinder and excavator frame. 1 P-33700 Remove the spacer (Item 1) [Figure 20-22-11] . 442 Excavator 20-22-4 Service Manual