Bobcat Company 442 — Removal And Installation

BOOM OFFSET CYLINDER (CONT’D) Removal And Installation (Cont’d) IMPORTANT Figure 20-22-14 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. I-2003-0888 1 Figure 20-22-16 1 P-33703 Start the excavator and fully retract the boom offset cylinder (Item 1) [Figure 20-22-14] . Figure 20-22-15 1 P-33705 Remove the rod end hose (Item 1) [Figure 20-22-16] . Figure 20-22-17 1 P-33704 2 To remove the cylinder, the cab must be tilted.

Use the blade (Item 1) [Figure 20-22-15] as an attaching point for the hand winch and tilt the cab. (SSee Tilting The Cab on Page 10-160-2). NOTE: Make sure the blade is not in the float position (if equipped) before tilting the cab. P-33706 Loosen the clamp (Item 1) [Figure 20-22-17] . Remove the block (Item 2) [Figure 20-22-17] . 20-22-5 442 Excavator Service Manual