Bobcat Company 442 — Assembly

BOOM OFFSET CYLINDER (CONT’D) Assembly Disassembly (Cont’d) Use the following tools to assemble the cylinder. Figure 20-22-40 MEL1396-Universal Seal Expander MEL1033-Rod Seal Installation Tool Piston Ring Compressor Wash the cylinder parts in clean solvent and dry with compressed air. Inspect the cylinder parts for nicks, scratches or other damage. Replace any damaged parts. 1 Always install new O-rings and seals during assembly. Lubricate all O-rings and seals with hydraulic oil during assembly. P-36086 Figure 20-22-41 Remove the bearing (Item 1) [Figure 20-22-40] . NOTE: The bearing can only be removed through the snap ring side of the housing.

1 P-36084 Install the bearing (Item 1) [Figure 20-22-41] in the rod end. NOTE: The bearing can only be installed from the snap ring side of the housing. 20-22-13 442 Excavator Service Manual