BOOM OFFSET CYLINDER (CONT’D) Figure 20-22-44 Assembly (Cont’d) Figure 20-22-42 P7427 Install the rod seal on the rod seal tool [Figure 20-22-44] . P-36085 NOTE: During installation the spring side of the seal must be toward the inside of the cylinder. Figure 20-22-43 Rotate the handles to collapse the rod seal [Figure 20- 22-44] . Figure 20-22-45 1 P-36086 Make sure the bearing is fully seated in the housing [Figure 20-22-42] and install the snap ring (Item 1) [Figure 20-22-43] . P-36081 Install the rod seal in the head [Figure 20-22-45] . 442 Excavator 20-22-14 Service Manual