BOOM OFFSET CYLINDER (CONT’D) Figure 20-22-48 Assembly (Cont’d) 2 Figure 20-22-46 1 2 1 3 P-36078 Install the O-ring (Item 1) and back-up ring (Item 2) [Figure 20-22-48] on the head. P-36080 Install the wiper (Item 1), wear ring (Item 2) and back-up ring (Item 3) [Figure 20-22-46] . Figure 20-22-49 Figure 20-22-47 1 P-35979 Install the new seal on the tool and slowly stretch it until it fits the piston [Figure 20-22-49] . P-36079 Allow the seal to stretch for 30 seconds before installing it on the piston. Install the two wear rings (Item 1) [Figure 20-22-47] . 20-22-15 442 Excavator Service Manual