BOOM OFFSET CYLINDER (CONT’D) Figure 20-22-56 Assembly (Cont’d) Figure 20-22-54 1 P-36070 1 Apply thread lock adhesive (Loctite™ 270) to the threads and install the nut (Item 1) [Figure 20-22-56] . P-36082 Clamp the rod end in a vise and support the end of the rod with a wood block (Item 1) [Figure 20-22-54] . Use care not to damage the rod. Tighten the nut to 1143 ft.-lb. (1550 N•m) torque. Figure 20-22-57 Figure 20-22-55 1 1 2 P-36083 P-36076 Install a ring compressor on the piston (Item 1) [Figure 20-22-57] and compress the seal to the correct size. Install the head (Item 1) and piston (Item 2) [Figure 20- 22-55] . Leave the piston in the compressor for three minutes.
Remove the rod and head assembly from the vise. 20-22-17 442 Excavator Service Manual