Bobcat Company 442 — Assembly

BOOM OFFSET CYLINDER (CONT’D) Figure 20-22-60 Assembly (Cont’d) Figure 20-22-58 3 2 1 P-36155 1 Clamp the base end of the cylinder in a vise and support the end of the housing with a block (Item 1) [Figure 20- 22-60] . Use care not to damage the cylinder housing. P-36066 Install the bearing (Item 1) [Figure 20-22-58] in to the base end of the cylinder housing. Support the rod assembly with wood blocks (item 2) [Figure 20-22-60] . NOTE: The bearing can only be installed through the snap ring side of the housing. Install a ring compressor (Item 3) [Figure 20-22-60] on the piston to compress the steel rings to the correct size. Figure 20-22-59 Push the piston into the housing.

Remove the ring compressor. Figure 20-22-61 1 1 P-36068 Fully seat the bearing and install the snap ring (Item 1) [Figure 20-22-59] . P-36065 Install the head (Item 1) [Figure 20-22-61] in the housing. 442 Excavator 20-22-18 Service Manual