Bobcat Company 442 — Assembly

BUCKET CYLINDER (CONT’D) Figure 20-23-113 Assembly (Cont’d) Figure 20-23-111 1 Clamp the base end of the cylinder in a vise and support the end of the housing with a block (Item 1) [Figure 20- 23-113] . Use care not to damage the cylinder housing. P-36067 Install the bearing (Item 1) [Figure 20-23-111] into the base end of the cylinder housing. Support the rod assembly with wood blocks (Item 2) [Figure 20-23-113] . NOTE: The bearing can only be installed through the snap ring side of the housing. Install a ring compressor (Item 3) [Figure 20-23-113] on the piston to compress the steel rings to the correct size. Figure 20-23-112 Push the piston into the housing.

Figure 20-23-114 1 1 P-36068 Fully seat the bearing and install the snap ring (Item 1) [Figure 20-23-112] . P-36065 Install the head (Item 1) [Figure 20-23-114] in the housing. 442 Excavator 20-23-15 Service Manual 3 2 1 P-36155 P-36155