Bobcat Company 442 — Removal And Installation

BLADE CYLINDER (CONT’D) Figure 20-24-5 Removal And Installation NOTE: The right blade cylinder is shown. The procedure is the same for the left blade cylinder. 1 Put the blade on the floor. With the engine off and the key in the run position, move the blade lever to relieve hydraulic pressure. IMPORTANT P-33449 When repairing hydrostatic and hydraulic systems, clean the work area before disassembly and keep all parts clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can quickly damage the system. Remove the bolt (Item 1) [Figure 20-24-5] and nut from the base end retaining pin. Installation: Tighten the bolt to 48-55 ft.-lb. (65-75 N•m) torque.

I-2003-0888 Figure 20-24-4 Figure 20-24-6 1 2 1 P-35918 P-33450 Remove the bolt (Item 1) [Figure 20-24-6] and nut from the rod end retaining pin. Remove the hose (Item 1) [Figure 20-24-4] from the base end of the cylinder. Installation: Tighten the bolt to 48-55 ft.-lb. (65-75 N•m) torque. Remove the hose (Item 2) [Figure 20-24-4] from the rod end of the cylinder. 442 Excavator 20-24-2 Service Manual