THREE SPOOL HYDRAULIC CONTROL VALVE (CONT’D) Figure 20-41-32 Inlet/Upperstructure Swing Valve Section Disassembly And Assembly (Cont’d) Figure 20-41-30 1 1 1 P-35785 Remove the spool (item 1) [Figure 20-41-32] from the valve. P-35783 Place the spool in the hardwood blocks. Install a wrench (Item 1) [Figure 20-41-30] on both ends of the spool. Remove the bolt. Place the spool/blocks in a vise. NOTE: Do not use anything other than hardwood blocks to grip the spool, or the spool will be damaged. Installation: Tighten the bolt to 80-97 in.-lb. (9-11 N•m) torque. Figure 20-41-31 Figure 20-41-33 2 1 1 1 P-35784 P-35779 Remove the bolt (Item 1) [Figure 20-41-33] .
Remove the spring seats (Item 1) and spring (Item 2) [Figure 20-41-31] . Installation: Tighten the bolt to 80-97 in.-lb. (9-11 N•m) torque. 442 Excavator 20-41-11 Service Manual