Bobcat Company 442 — Pump Testing

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-7 4 Pump Testing 5 Torque Limiter Supply Pressure Adjustment Figure 20-50-5 3 2 1 P-40566 1 Install a fitting and drain hose (Item 1) [Figure 20-50-7] . Place the other end of the hose in a drain pan. P-33366 NOTE: To adjust the Torque Limiter Supply Pressure, the Pump Margin Spool must be temporarily bottomed out. Install a 725 PSI (500 bar) pressure gauge on the test coupler (Item 1) [Figure 20-50-5] . Loosen the nut (Item 2) [Figure 20-50-7] . Turn the pump margin spool (bottom spool) (Item 3) [Figure 20-50-7] all the way in (approximately 6 turns). Figure 20-50-6 Start the engine and run at high idle.

Loosen the nut (Item 4) and adjust the torque limiter supply pressure spool (Item 5) [Figure 20-50-7] until the pressure gauge reads 290 PSI (20 bar). 2 1 Turn the adjustment screw clockwise to increase pressure and counterclockwise to decrease pressure. NOTE: 1/4 turn is approximately 35 PSI (2,41 bar). Tighten the nut (Item 4) [Figure 20-50-7] . Stop the engine. P-40560 Remove caps (Item 1) [Figure 20-50-6] . Repeat the procedure listed above until the pressure is set. Turn the pump margin spool (bottom spool) (Item 3) [Figure 20-50-7] back to its original position (approximately 6 turns). Remove the plug (Item 2) [Figure 20-50-6] . Tighten the nut (Item 2) [Figure 20-50-7] .

Remove the hose (Item 1) [Figure 20-50-7] and install the plug. Install the cap on the torque limiter supply pressure adjustment spool (top spool). 442 Excavator 20-50-6 Service Manual