Bobcat Company 442 — Pump Testing

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-9 Pump Testing (Cont’d) Pump Margin Pressure Adjustment Figure 20-50-8 1 2 P-40560 Install the cap (Item 1) [Figure 20-50-9] on the pump margin pressure adjustment spool (bottom spool). 1 P-40562 Remove the gauge from the test coupler. Start the engine and run at high idle. Loosen the nut (Item 1) and adjust the pump margin pressure adjustment spool (Item 2) [Figure 20-50-8] until the pressure gauge reads 363 PSI (25 bar). Turn the adjustment screw clockwise to increase pressure and counterclockwise to decrease pressure. NOTE: 1/4 turn is 50 PSI (3,45 bar). Tighten the nut (Item 1) [Figure 20-50-8] . Stop the engine.

442 Excavator 20-50-7 Service Manual