HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-15 Pump Testing (Cont’d) Load Sense Relief Valve Adjustment Figure 20-50-14 1 P-33367 2 1 Remove the plastic cap (Item 1) [Figure 20-50-15] . Figure 20-50-16 P-33366 Install a 5000 PSI (345 bar) pressure gauge on the test coupler (Item 1) [Figure 20-50-14] . Move the engine speed control to the high idle position. 1 2 Curl the bucket until the bucket cylinder is fully extended and the relief valve opens. Record the pressure. The pressure at the gauge (Item 2) [Figure 20-50-14] should be 4060 PSI (280 bar). P-33368 Stop the engine. Loosen the lock nut (Item 1) [Figure 20-50-16] .
Turn the adjustment screw (Item 2) [Figure 20-50-16] in to increase pressure and out to decrease pressure. NOTE: One quarter turn is approximately 200 PSI (13,8 bar). Tighten the lock nut and retest the load sense relief valve. 442 Excavator 20-50-9 Service Manual