HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Pump Control Removal And Installation Clean the outside of the pump with clean solvent and dry with compressed air before removing any components from the pump. Figure 20-50-80 1 P-35319 Mark the tubeline (Item 1) [Figure 20-50-80] for correct assembly. Loosen and remove the tubeline (Item 1) [Figure 20-50- 80] from the pump control and torque limiter valve. Figure 20-50-81 1 1 P-35331 Loosen and remove the 4 bolts (Item 1) and remove the pump control (Item 2) [Figure 20-50-81] from the hydraulic piston pump. Installation: Tighten the bolts to 10 ft.-lb. (13 N•m) torque. 442 Excavator 20-50-32 Service Manual