Bobcat Company 442 — Disassembly

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-118 Disassembly (Cont’d) 1 Figure 20-50-116 2 4 4 3 3 2 1 2 3 4 N-15289 Install the second trimmed washer (Item 1) over the threaded rod (Item 2) install the nut (Item 3) [Figure 20- 50-118] . N-15299 NOTE: The modified washer (Item 1) must fit between the 3 pins (Item 4) [Figure 20-50-118]. To remove the spring from inside the cylinder block, use a threaded rod (or bolt) (Item 1) 2 trimmed washers (Item 2) and 2 nuts (Item 3) [Figure 20-50-116] . Figure 20-50-119 Figure 20-50-117 4 1 2 1 2 3 N-15290 N-15288 Tighten the nut (Item 1) until the spring is compressed enough to remove the snap ring (Item 2) [Figure 20-50- 119] .

Install the threaded rod and nut (Item 1) through the trimmed washer (Item 2) and through the block assembly (Item 3) [Figure 20-50-117] . Loosen the nut to release the tension on the spring and remove the bolts and washers. NOTE: The modified washer (Item 2) must fit over the spring but must also fit inside the snap ring (Item 4) [Figure 20-50-117]. 442 Excavator 20-50-43 Service Manual