HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-147 Assembly (Cont’d) Figure 20-50-146 1 1 N-15277 Install the two brass bearings (Item 1) [Figure 20-50- 147] . P-35359 Figure 20-50-148 Install a dial indicator on the housing as shown [Figure 20-50-146] and set it to zero. Pull the shaft up as far as it will go and record the reading on the dial indicator. Repeat the procedure several times. The reading must be the same each time. 3 Add the nominal pre-load of 0.001 inch (0,025 mm), the actual pre-load is 0.000 inch (0,000 mm) to 0.002 inch (0,050 mm) to the reading found on the dial indicator [Figure 20-50-146] . 1 2 Example:
(In Inches) 0.150 Measured movement of shaft N-15283 0.001 Nominal Pre-load Apply Loctite™ 241 and install the torque limiter plate (Item 1) and bolt (Item 2) on the swash plate (Item 3) [Figure 20-50-148] . = 0.151 ± thickness of the spacer needed. (See Assembly (Cont’d) on Page 20-50-50.) When the proper thickness of shim washer is determined, remove the dial indicator from the pump housing. Remove the two mounting bolts. Remove the port block. Remove the bearing and shaft from the pump housing. 442 Excavator 20-50-51 Service Manual