Bobcat Company 442 — Assembly

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-159 Assembly (Cont’d) Figure 20-50-157 1 N-23390 Install the shim washer (Item 1) [Figure 20-50-159] See “Assembly” on page 48. for procedure to determine shim washer thickness.) Figure 20-50-160 NOTE: The modified washer (Item 1) must fit over the spring, but must also fit inside the snap ring (Item 2) [Figure 20-50-157]. Figure 20-50-158 1 2 2 1 N-23386 Install the bearing (Item 1) [Figure 20-50-160] on the shaft. N-15290 Install a new O-ring (Item 2) [Figure 20-50-160] . Tighten the nut (Item 1) until the spring is compressed enough to install the snap ring (Item 2) [Figure 20-50- 158] .

Remove the threaded rod/washer assembly. Set the pump housing in the up-right position. 442 Excavator 20-50-54 Service Manual 2 1 3 N-15288 N-15288