Bobcat Company 442 — Assembly

HYDRAULIC PISTON PUMP (S/N 522311001 & ABOVE) (CONT’D) Figure 20-50-171 Assembly (Cont’d) Figure 20-50-169 1 3 1 2 N-23355 Install the pin assembly (Item 1) [Figure 20-50-171] . P-35349 Make sure the dowel pin (Item 2) is fully seated in the hole (Item 3) [Figure 20-50-171] on the swash plate. Install the O-ring (Item 1) [Figure 20-50-169] on the plug. Figure 20-50-172 Figure 20-50-170 1 1 1 N-23354 P-35368 Apply Loctite™ 241 on the bolt (Item 1) [Figure 20-50- 172] . Tighten the bolt to 10 ft.-lbs. (13 Nm) torque. Install the plugs (Item 1) [Figure 20-50-170] . Install the torque limiter valve. See “Torque Limiter Valve Removal and Installation” on page 20.

Install the pump control assembly. See “Pump Control Removal And Installation” on page 32. 442 Excavator 20-50-57 Service Manual