HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Curl the bucket until the bucket cylinder is fully extended and the relief valve opens. Pump Testing (Cont’d) Record the pressure. Back-up Relief Valve Adjustment (Cont’d) The pressure at the gauge (Item 2) [Figure 20-52-11] should be 4060 PSI (280 bar). Figure 20-52-10 Stop the engine. 1 Figure 20-52-12 2 1 P-58099 Loosen the lock nut (Item 1) [Figure 20-52-10] . P-33367 Turn the adjustment screw (Item 2) [Figure 20-52-10] in to increase pressure and out to decrease pressure. Remove the plastic cap (Item 1) [Figure 20-52-12] . NOTE: One quarter turn is approximately 200 PSI (13,8 bar).
Figure 20-52-13 Tighten the nut and retest the backup relief valve. Load Sense Relief Valve Adjustment Figure 20-52-11 1 2 1 P-33368 2 Loosen the lock nut (Item 1) [Figure 20-52-13] . Turn the adjustment screw (Item 2) [Figure 20-52-13] in to increase pressure and out to decrease pressure. P-58095 NOTE: One quarter turn is approximately 200 PSI (13,8 bar). Install a 5000 PSI (345 bar) pressure gauge on the test coupler (Item 1) [Figure 20-52-11] . Tighten the lock nut and retest the load sense relief valve. Move the engine speed control to the high idle position. 442 Excavator 20-52-8 Service Manual