Bobcat Company 442 — Pump Testing

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-9 Pump Testing (Cont’d) Pump Margin Pressure Adjustment (Cont’d) Figure 20-52-8 1 1 P-58098 2 Remove the plastic cap (Item 1) [Figure 20-52-9] . P-58095 Install a 5000 PSI (345 bar) pressure gauge on the test coupler (Item 1) [Figure 20-52-8] . Start the excavator and warm the hydraulic oil to operating temperature. Move the engine speed control to the high speed position. Curl the bucket until the bucket cylinder is fully extended and the relief valve opens. Record the pressure. The pressure at the gauge (Item 2) [Figure 20-52-8] should be 4350 PSI (300 bar). Stop the engine.

442 Excavator 20-52-7 Service Manual