Bobcat Company 442 — Pump Testing

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-6 Pump Testing (Cont’d) Pump Margin Pressure Adjustment 1 Figure 20-52-5 2 P-58094 Install the cap (Item 1) [Figure 20-52-6] on the pump margin pressure adjustment spool (bottom spool). 1 P-40562 Remove the gauge from the test coupler. Back-up Relief Valve Adjustment Start the engine and run at high idle. Figure 20-52-7 Loosen the nut (Item 1) and adjust the pump margin pressure adjustment spool (Item 2) [Figure 20-52-5] until the pressure gauge reads 363 PSI (25 bar). Turn the adjustment screw clockwise to increase pressure and counterclockwise to decrease pressure. NOTE:

1/4 turn is 50 PSI (3,4 bar). Tighten the nut (Item 1) [Figure 20-52-5] . 1 Repeat the procedure listed above until the pressure is set. Stop the engine. P-33368 Turn the load sense adjustment screw (Item 1) [Figure 20-52-7] in 3/4 of a turn, increasing the relief pressure approximately 600 PSI (41,3 bar) to 4660 PSI (321 bar).The load sense relief is now set to a higher pressure than the backup relief. 442 Excavator 20-52-6 Service Manual