HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-4 Pump Testing 4 5 Torque Limiter Supply Pressure Adjustment Figure 20-52-2 1 3 2 2 P-58096 1 Install a fitting and drain hose (Item 1) [Figure 20-52-4] . Place the other end of the hose in a drain pan. P-58095 NOTE: To adjust the Torque Limiter Supply Pressure, the Pump Margin Spool must be temporarily bottomed out. Install a 725 PSI (500 bar) pressure gauge on the test coupler (Item 1) [Figure 20-52-2] . Loosen the nut (Item 2) [Figure 20-52-4] . Turn the pump margin spool (bottom spool) (Item 3) [Figure 20-52-4] all the way in.
(Approximately 6 turns) Figure 20-52-3 Start the engine and run at high idle. Loosen the nut (Item 4) and adjust the torque limiter supply pressure spool (Item 5) [Figure 20-52-4] until the pressure gauge reads 290 PSI (20 bar). 1 Turn the adjustment screw clockwise to increase pressure and counterclockwise to decrease pressure. 2 NOTE: 1/4 turn is approximately 35 PSI (2,4 bar). Repeat the procedure listed above until the pressure is set. P-58094 Tighten the nut (Item 4) [Figure 20-52-4] . Remove caps (Item 1) [Figure 20-52-3] . Stop the engine. Turn the pump margin spool (bottom spool) (Item 3) [Figure 20-52-4] back to its original position.
(Approximately 6 turns) Remove the plug (Item 2) [Figure 20-52-3] . Tighten the nut (Item 2) [Figure 20-52-4] . Remove the hose (Item 1) [Figure 20-52-4] and install the plug. Install the cap on the torque limiter supply pressure adjustment spool (top spool). 442 Excavator 20-52-5 Service Manual