HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-24 Pump Testing (Cont’d) Figure 20-52-22 3 1 1 2 P-40580 The flow should be 43 GPM (163 L/mm) on the flow tester (Item 1) [Figure 20-52-24] . P-58094 Turn the hydraulic tester flow control (Item 2) clockwise until the gauge (Item 3) [Figure 20-52-24] shows 1450 PSI (100 bar). Remove the cap (Item 1) [Figure 20-52-22] from the pump margin spool (bottom spool). The gauge (Item 1) [Figure 20-52-24] should show 41 GPM (155 L/min) which is flow at low pressure .
Figure 20-52-23 Figure 20-52-25 2 1 1 P-58097 Loosen the nut (Item 1) and turn the adjustment screw (Item 2) [Figure 20-52-23] all the way in (approximately 6 turns). P-58650 Remove the dust cover (Item 1) [Figure 20-52-25] . Start the engine and run at high idle. 442 Excavator 20-52-11 Service Manual