Bobcat Company 442 — Disassembly

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-106 Disassembly (Cont'd) 2 Figure 20-52-104 1 1 N-15287 Remove the retainer plate and pistons (Item 1) from the cylinder block (Item 2) [Figure 20-52-106] . N-23391 NOTE: The following procedure shown is to disassemble the rotating group for inspection only. The rotating group parts can not be ordered separately and must be ordered as an assembly. Lay the pump assembly on its side and remove the rotary group, cradle, and shaft (Item 1) [Figure 20-52-104] from the housing.

Figure 20-52-105 Figure 20-52-107 1 3 2 1 2 3 2 N-23392 N-15299 Slide the rotary group (Item 1) from the shaft assembly (Item 2) [Figure 20-52-105] . To remove the spring from inside the cylinder block, use a threaded rod (or bolt) (Item 1) two trimmed washers (Item 2) and two nuts (Item 3) [Figure 20-52-107] . NOTE: It is NOT important that the pistons are installed in their original positions. NOTE: Check that there are no scratches or metal deposits on the sliding surface. (Pistons must be replaced in sets). 442 Excavator 20-52-39 Service Manual