Bobcat Company 442 — Disassembly

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Figure 20-52-110 Disassembly (Cont'd) Figure 20-52-108 2 4 1 1 2 N-15290 3 Tighten the nut (Item 1) until the spring is compressed enough to remove the snap ring (Item 2) [Figure 20-52- 110] . N-15288 Loosen the nut to release the tension on the spring and remove the bolts and washers. Install the threaded rod and nut (Item 1) through the trimmed washer (Item 2) and through the block assembly (Item 3) [Figure 20-52-108] . Figure 20-52-111 NOTE: The modified washer (Item 2) must fit over the spring but must also fit inside the snap ring (Item 4) [Figure 20-52-108].

Figure 20-52-109 1 3 2 1 2 4 4 3 N-15291 4 Remove the spring (Item 1) the washer (Item 2) and the 3 pins (Item 3) [Figure 20-52-111] from the cylinder block. N-15289 Install the second trimmed washer (Item 1) over the threaded rod (Item 2) install the nut (Item 3) [Figure 20- 52-109] . NOTE: The modified washer (Item 1) must fit between the three pins (Item 4) [Figure 20-52-109]. 442 Excavator 20-52-40 Service Manual