Bobcat Company 442 — Assembly

HYDRAULIC PISTON PUMP (S/N 528911001 & ABOVE AND S/N 528611001 & ABOVE) (CONT’D) Example: (In Inches): 0.150 Measure movement of shaft Assembly (Cont'd) Figure 20-52-137 0.001 Nominal Pre-load = 0.151 ± thickness of the spacer needed. When the proper thickness of shim washer is determined, remove the dial indicator from the pump housing. Remove the two end plate mounting bolts from the pump. Remove the shaft/bearing assembly from the pump housing. Figure 20-52-138 N-23430 1 Install a dial indicator on the housing as shown [Figure 20-52-137] and set it to zero. 1 Pull the shaft up as far as it will go and record the reading on the dial indicator. Repeat the procedure several times.

The reading must be the same each time. Add the nominal pre-load of 0.001 inch (0,025 mm), the actual pre-load is 0.000 inch (0,000 mm) to 0.002 inch (0,050 mm) to the reading found on the dial indicator [Figure 20-52-137] . N-15277 Install the 2 brass bearings (Item 1) [Figure 20-52-138] into the pump housing. 442 Excavator 20-52-48 Service Manual